TM 55-1520-240-23-4
5-48.6
INSTALL DROOP STOP SHROUD BASE
(Continued)
5-48.6
4.
Install four washers (7) and bolts (8) in base (2).
Torque bolts to 70 inch-pounds.
5.
Install washer (9) and bolt (10) in base (2).
Torque bolt to 70 inch-pounds.
6.
Tighten two nuts (6) until rubber of bushings (4)
is compressed 0.010 to 0.030 inch and cotter
pin (11) holes are aligned with nut slots. Use
additional washers (5) if required. Install cotter
pins.
7.
Install lockwire between bolts (10 and 12). Use
lockwire (E231).
FOLLOW-ON MAINTENANCE:
Install droop stop shroud shield (Task 5-48.7).
END OF TASK
5-216