• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL HORIZONTAL HINGE PIN, PITCH-VARYING HOUSING, AND PIN BEARINGS (Continued) INSTALL PITCH-VARYING HOUSING
INSTALL HORIZONTAL HINGE PIN, PITCH-VARYING HOUSING, AND PIN BEARINGS     (Continued) - TM-55-1520-240-23-4_221

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  195    196    197    198    199  200  201    202    203    204    205  
TM 55-1520-240-23-4 5-46 INSTALL HORIZONTAL HINGE PIN, PITCH-VARYING HOUSING, AND PIN BEARINGS     (Continued) 5-46 WARNING Antiseize compound (E75) can form toxic vapors if exposed to flame. Use in well-ventilated area, away from open flame.  In case of contact, immediately flush skin or eyes with water for at least  15 minutes.  Get medical attention for eyes. 16. Coat tie-bar pin (22).  Use antiseize compound (E75).  Install pin on  3/8 inch x 24 thread x 5 inch bolt (23).  Wear gloves (E186). CAUTION Do not misalign tie-bar pin during installation.  Rotary-wing head will be damaged at maximum flap angle. Nut plate at pitch shaft will also be damaged. 17. Align pin (22) so slot (24) in pin is aligned with slot (25) in pitch-varying shaft (11).  Install pin. Remove bolt (23). 18. Position retaining washer pin (26) over slots (24 and 25).  Install retaining washer (27). 5-202 Change 2







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.