• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  HORIZONTAL HINGE  PIN OIL SEALS (Continued)
REMOVE  HORIZONTAL  HINGE  PIN,  PITCH-VARYING  HOUSING  AND  PIN BEARINGS (Continued)

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  180    181    182    183    184  185  186    187    188    189    190  
TM  55-1520-240-23-4 5-44 REMOVE  HORIZONTAL HINGE  PIN, PITCH-VARYING HOUSING AND PIN BEARINGS 5-44 INITIAL  SETUP Applicable Configurations: All Tools: Powertrain   Repairer’s  Tool  Kit,   NSN 5180-00-003-5267 Horizontal  Hinge  Pin  Pusher (T87) Bolt,  3/8-24  Thread  X  5  Inches Drift (2), Brass,  1/2  Inch  Diameter Flattened  At One End Horizontal  Hinge  Pin  Bearing  Puller  (T9) Container,  2  Quart Materials: Grease  (E190) Pencil,  Marking  (E271) Gloves  (E186) Personnel  Required: Aircraft  Powertrain  Repairer (2) References: Task  5-42 Equipment  Condition: Off  Helicopter  Task Horizontal  Hinge  Pin  Bearing  Caps  Removed  (Task 5-40) Hub  Oil Tank  Removed  (Task  5-15) NOTE Procedure  is  same  to  remove  any horizontal  hinge  pin,  pitch-varying housing,  and  pin  bearing  assembly. There  are  three  horizontal  hinge pins,  six  pin  bearings,  and  three pitch-varying  housings  on  a rotary-wing  head.   Forward  head  is shown  here. 5-187







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.