TM 55-1520-240-23-4
5-22
REMOVE PITCH-VARYING HOUSING
(Continued)
5-22
5.
Tie weights (8, 9, and 10) together with tag
(E264) (11). Mark tag with color of tape (12)
(E404) on housing (5).
6.
Remove nut (13), bolt (14), and washer (15).
7.
Remove two washers (16). Pry washers loose
from sealant.
Do not try to tap tie-bar pin out
through bottom of housing. Damage
to pin and tie-bar will result.
8.
Tap tie-bar pin (17) upward out of housing (5).
Use phenolic drift.
Do not allow dirt or abrasive
materials to contact bearing races.
Avoid handling pitch-varying shaft.
Fingerprints can cause corrosion on
bearing surfaces.
9.
Pull housing (5) from shaft (18). Tap housing with
soft mallet if needed.
5-112