• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL AND RIG  THRUST CONTROL POSITION TRANSDUCER ASSEMBLY
INSTALL  AND  RIG  THRUST  CONTROL  POSITION  TRANSDUCER ASSEMBLY (Continued) - TM-55-1520-240-23-3_738

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  694    695    696    697    698  699  700    701    702    703    704  
TM  55-1520-240-23-3 4-153 INSTALL  AND  RIG  THRUST  CONTROL  POSITION  TRANSDUCER ASSEMBLY (Continued) 4-153 2. Install  bolt  (4),  two  new  washers  (5),  bushing (6),  nut  (7),  and  cotter pin  (8) through  fulcrum assembly. INSPECT NOTE Before adjusting  thrust control position transducer  rod  end,  ensure  that flight controls  have  been  rigged  to  neutral position  (Task  11-33). 3. Loosen  jamnut  (9).   Adjust  rod  end  (10)  to achieve  clearance  dimension  of not  more  than 1.13 inches or less  than  1.07  inches  on  thrust control  transducer assembly (1). When  a  light washer is used under the nut prior to  applying  nut torque,  make certain  that washer does  not hang  up in  the  bolt  retaining  groove.   If  this condition  is  allowed  to  exist, damage can  result  to  associated  hardware and/or  prevent proper  clamp-up. NOTE Bolt  and  nut  installation  is  not acceptable  if,  after  tightening  nut to  torque  value,  the  bolt  and  nut assembly  can  be  rotated  with  a  torque less  than  10 inch-pounds  and/or any axial  looseness  exists.   If  either condition  is  present,  add  washer under nut  and  retorque. 4-499







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.