INSTALL AFT LANDING GEAR WHEEL AND TIRE ASSEMBLY
Dry cleaning solvent (E162) is
flammable and gives off toxic fumes.
It may irritate skin and cause burns.
Use only in well-ventilated area, away
from heat and open flame. In case
of contact, immediately flush skin
or eyes with water for at least 15
minutes. Get medical attention for
Never stand facing sidewall of tire
being serviced. Stand facing tire
Oil (E254/E254.1) is toxic. It can
irritate skin and cause burns. Avoid
inhaling. Use only with adequate
ventilation. Avoid contact with skin,
eyes, or clothing. In case of contact,
immediately flush skin or eyes for
at least 15 minutes. Get medical
attention for eyes.
Dirt and mixed greases on bearings
and bearing surfaces can cause
damage to wheels. Clean bearings
and surfaces before packing.
Procedures are same for installing left
or right wheel. Left wheel is shown
Clean bearings (1 and 2) and wheel surfaces
thoroughly with dry cleaning solvent (E162).
Wear gloves (E186).
Clean seals (3 and 4) with dry cloths (E120).
Pack bearings (1 and 2) with grease (E190).
Install bearing (1) in bearing cup (5).
Insert seal (3) over bearing (1).
Install bearing (2) in bearing cup (6).
Insert seal (4) over bearing (2).