REPLACE ENGINE SCREEN ACCESS DOOR LATCHES
REPLACE LATCH CABLES AND PINS
Cut cable (6) and remove from latch pins (1) and
Replace pins (1), as required.
Cut new cable (6) to 13.31 inches.
Thread new cable (6) thru eyelet (5) and pass
each end (13) through new ferrule (14).
Thread cable ends (13) thru pin loops (15) and
back thru ferrules (14).
Crimp ferrules (14).
Adhesive (E27) is toxic. It can
irritate skin and cause burns. Avoid
inhaling. Use only with adequate
ventilation. Avoid contact with skin,
eyes, or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Prepare adhesive (E27) (Task 2-317). Coat all
rivet heads with adhesive. Allow adhesive to
END OF TASK