• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPAIR  CONNECTING  LINK  (DRAG  STRUT)  AND  ENGINE  MOUNT  FITTINGS (AVIM) (Continued) - TM-55-1520-240-23-3_460
REPAIR  CONNECTING  LINK  (DRAG  STRUT)  AND  ENGINE  MOUNT  FITTINGS (AVIM) (Continued) - TM-55-1520-240-23-3_462

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  430    431    432    433    434  435  436    437    438    439    440  
TM  55-1520-240-23-3 4-42 REPAIR  CONNECTING LINK  (DRAG STRUT)  AND  ENGINE  MOUNT  FITTINGS (AVIM) (Continued) 4-42 b. Ream  lug  (4)  in  line  with  other  lug  (5).  Make a  round  hole  (6)  with  an  inside  diameter  (7) no  larger  than  0.6562 inch. c. Measure  inside  diameter  (7)  of  hole  (6  and 11).   Record  measurement. d. Measure  width  (12)  of  lug  (13).   Record measurement. e. Measure  width  (14)  of  lug  (15).   Record measurement. f. Make  new  shoulder  bushing  (1)  from  steel (E367)  as  follows: (1) Make  bushing  length  (16)  from  flat  end (17)  to  counterbore  (18)  equal  to  lug width  (12).  (See  measurement recorded in  step  d.) (2) Make  outside  diameter  (19)  of bushing (1)  0.0008  to  0.0020  inch  more  than inside  diameter  (7)  of  hole  (6).   (See measurement recorded  in  step  c.) (3) Make  inside  diameter  (20)  of bushing  (1) 0.500  inch. (4) Make  outside  diameter  (21)  of  shoulder (22)  0.07500 inch. (5) Make  width  (23)  of  shoulder  (22)  0.062 inch. g. Make  new  shoulderless  bushing  (2)  from steel  (E367)  as follows: (1) Make  bushing  length  (24)  0.4012  to 0.4062  inch. (2) Make  outside  diameter  (25)  0.0008  to 0.0023  inch more  than  inside  diameter  of hole  (7).   (See  measurement  recorded in  step  c.) (3) Make  inside  diameter  (26)  of bushing  (2) 0.500  inch. 4-223







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.