• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  FORWARD  ENGINE  MOUNT ADAPTER (Continued) - TM-55-1520-240-23-3_426
INSTALL FORWARD  ENGINE  MOUNT ADAPTER (Continued) - TM-55-1520-240-23-3_428

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  396    397    398    399    400  401  402    403    404    405    406  
TM  55-1520-240-23-3 4-35.1 INSTALL FORWARD  ENGINE  MOUNT ADAPTER (Continued) 4-35.1 6. Install  slip-fit  bushing  (12),  shoulder  outboard, in  clevis  (10). 7. Install  bolt  (13),  two  washers  (14),  spacer  (15), and  nut  (16).   Raise  or lower engine  (3)  as needed  for clearance. 8. Torque  nut (16) to  350  to 400  inch-pounds  to seat  bushing.   Loosen  nut  and  retorque  to  20 inch-pounds above  run  on  torque  and  not less than  70 inch-pounds. INSPECT 9. Check  barrel  nuts  (17).  Rotational  torque  shall not  be  less than  7  inch-pounds. 10. Push  four bolts  (18) up  and  over adapter (1) and tighten  evenly. 11. Torque  bolts  (18)  to  20  inch-pounds  above friction  torque. 12. Relax  tension  on  hoist  (7). 13. Re-torque  bolts (18) to  95 to 110 inch-pounds. 14. Measure  gap  between  adapters (1) and  caps  (8). Gap  shall  measure  0.010  to 0.070 inch. 15. Check  bolts  (18).  Bolts shall  extend  a  minimum of two  threads through  barrel  nuts (17)  but  shall not  bottom  out.  If bolts bottom  out,  add  washers under  bolt  head  and  repeat  steps  13  and  14. Lockwire  bolts  (18).  Use  lockwire  (E231). 4-189







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.