TM 55-1520-240-23-3
4-24
REPLACE STARTER DRIVE SHAFT SEAL
4-24
INITIAL SETUP
Applicable Configurations:
All
Tools:
Powerplant Repairers Tool Kit, NSN
5180-00-323-4944
Materials:
None
Personnel Required:
Aircraft Powerplant Repairer (2)
References:
TM 55-2840-254-23 Without 74
TM 55-2840-254-23P Without 74
TM 1-2840-265-23 With 74
TM 1-2840-265-23P With 74
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Engine Work Platform Open (Task 2-2)
Engine Access Cover Open (Task 4-49)
Starter Removed (Task 7-141)
NOTE
Procedure is same to replace starter
drive shaft seal on No. 1 or No. 2
engine. No. 1 engine is shown here.
1.
Replace starter drive shaft seal (TM
55-2840-254-23 without 74 , TM 1-2840-265-23
with 74 ).
FOLLOW-ON MAINTENANCE:
Install starter (Task 7-142).
Close engine access cover (Task 4-50).
Close engine work platform (Task 2-2).
END OF TASK
4-146