TM 55-1520-240-23-3
4-16
INSTALL ENGINE FUEL CONTROL
(Continued)
4-16
6.
Connect hose (13) to elbow (14).
7.
Position lever (15) on shaft (16). Install bolt (17),
two washers (18), nut (19), and cotter pin (20).
8.
Position lever (21) on shaft (22). Install bolt (23),
two washers (24), nut (25), and cotter pin (26).
9.
Install the N2 RPM limiting stop on fuel control
(TM 55-2840-254-23).
INSPECT
FOLLOW-ON MAINTENANCE:
Perform operational check of gas producer control
system (TM 55-1520-240-T).
Perform operational check of power turbine control
system (TM 55-1520-240-T).
Prime fuel control (TM 55-2840-254-23).
Adjust fuel control (TM 55-2840-254-23).
Perform engine teac check (Task 4-3).
Close engine access cover (Task 4-50).
Close engine work platform (Task 2-2).
END OF TASK
4-132