TM 55-1520-240-23-3
3-76
INSTALL BRAKE LINING
(Continued)
3-76
NOTE
Procedure is same for all brakes.
1.
Clean old adhesive from anvil (1) and piston (2).
Use methyl-ethyl-ketone (E244). Wipe anvil dry
with cloth (E120). Wear gloves (E186).
Replace brake linings as complete set
of six. Partial replacement will result
in uneven wear and make brakes
unreliable.
Use all asbestos or all non-asbestos
brake linings in any single brake
assembly. Brake assemblies
containing asbestos linings and brake
assemblies containing non-asbestos
linings may be used on the same
aircraft.
NOTE
Adhesive will hold lining in place
during assembly.
2.
Apply adhesive (E31) to back of three new linings
(3) around raised key (4). Wear gloves (E186).
3.
Install three linings (3) in anvil (1). Make sure
keys (4) on linings fit keyway (5) in anvil.
3-201