• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPAIR  LOWER  DRAG  LINK  (AVIM)
ASSEMBLE LOWER DRAG LINK (AVIM)     (Continued)

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  115    116    117    118    119  120  121    122    123    124    125  
TM  55-1520-240-23-3 3-47 ASSEMBLE  LOWER  DRAG  LINK  (AVIM) 3-47 INITIAL  SETUP Applicable  Configurations: All Tools: Machine  Shop  Set, NSN 4920-00-405-9279 Arbor  Press Reamer with  1.876  to  1.877  Inch  Capability Vernier  Caliper,  24  Inch Gun  Type  Electric  Heater Materials: Epoxy Primer  (E292) Adhesive  (E43) Temperature  Indicating  Strips (E413) Gloves  (E184.1) Kevlar  Gloves  (E187) Parts: Bushings Instruction  Plate Personnel  Required Machinist Inspector References: TM  55-1520-240-23P Equipment  Condition: Off  Helicopter  Task Epoxy  primer  (E292)  is  flammable and  toxic.   It  can  irritate  skin  and cause  burns.  Use  only with  adequate ventilation, away  from  heat or open flame.   Avoid  contact  with  skin,  eyes, or  clothing.   In  case  of  contact, immediately  flush  skin  or eyes  with water for  at  least  15 minutes.   Get medical  attention  for eyes. NOTE Procedure  is same  for  left  or  right landing  gear lower  drag  link. 1. Coat contact surfaces of new bushings (1)  with primer (E292).  Wear  gloves  (E184.1). 2. While  primer is  wet, install  bushings (1)  in  drag link (2).  Use  arbor press. 3-122







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.