TM 55-1520-240-23-11
17-6
ASSEMBLE EMERGENCY EXIT LIGHT
(Continued)
17-6
ASSEMBLE HOUSING
1.
Apply small amount of sealant (E328) inside
housing (1) around edge of hole (2).
2.
Install bushing (3), washer (4), and nut (5).
3.
Apply small amount of sealant (E328) under lip
of bushing (6).
4.
Install packing (7) in bushing (6). Install bushing
in housing (1).
5.
Slide shaft (8) through bushing (6) and install nut
(9), adapter (10), washer (11), and screw (12).
6.
Apply adhesive (E33) around edge of lens
mounting (13) inside housing (1).
7.
Install lens (14), smooth side out.
8.
Apply adhesive (E33) around edge of lens (14).
9.
Install reflector (15) over lens (14).
10.
Heat three tabs (16) to hold reflector (15) to
housing (1).
17-16