INSPECTION AND RELATCHING OF CENTER HOOK MANUAL RELEASE
Secure manual release handle (13) in angle
plate (15) and cradle (16).
Move hook (5.1) to the left until it stops
against beam (17) and then to the right until it
stops against beam (17). There shall be no
tension on cable (14.1) when hook is moved.
Ensure release lever (12) did not move.
If performing a third manual release
under load, continue with step 4. If
not performing third release, go to
After every third manual release under load,
perform a special inspection as follows:
Remove hook (5.1) (Task 16-4).
Disassemble hook (5.1) (Task 16-5).