TM 55-1520-240-23-10
14-21
REMOVE TACKLE BLOCKS/CABLE BLOCKS (RESCUE MODE)
14-21
INITIAL SETUP
Applicable Configurations:
All
Tools:
None
Materials:
None
Personnel Required:
Medium Helicopter Repairer
References:
Task 14-15
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Hydraulic Power Off
Make sure there is no load on cable.
Serious injury to personnel or damage
to equipment can occur.
NOTE
Procedure is same for all tackle blocks
except aft cable block. Aft cable block
may have cable cutter installed.
1.
Hold pulley (1) and remove quick disconnect pin
(2). Remove pulley (1).
2.
Remove cable (3) from cable block (4).
3.
Position pulley (1) in cable block (4). Install pin
(2).
4.
For an aft cable block, remove cable cutter (5), if
installed (Task 14-15).
5.
Push in keeper (6) and remove cable block (4).
6.
Stow cable or tackle blocks in pockets (7) of
stowage container (8).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
14-57