• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL CABLE  CUTTER
INSTALL CABLE  CUTTER (Continued)

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  322    323    324    325    326  327  328    329    330    331    332  
TM  55-1520-240-23-10 14-17 INSTALL  CABLE  CUTTER (Continued) 14-17 NOTE If cable  block  will  be  used,  perform steps  3  thru  7.  If cable  block will  not be  used, go  to  step  8. 3. Install  cable  block  (7)  on  overhead  hook  (8). 4. Remove  quick-disconnect  pin  (9)  and  remove pulley  (10). 5. Place  cable  (11)  between  pulley (10) and  cable block  (7). 6. Place  pulley (10) in  cable block (7).  Install pin  (9). 7. Retain  cable  (11)  between  rollers  (12)  by installing  forward  half  of  cable  cutter  (1). A  loaded  cutter  is a  hazard.   Insert cartridge  only  if cutter  is to  be  used. Do  not  install  if cutter will be  stowed. 8. Push  in  lockpin  (13).   Install  locknut  (14). 9. If cutter  is to  be  used,  insert  cartridge  (15) (Task 1-75). 9.1. Write  cartridge  lot number,  date  cartridge  was installed,  and  date  cartridge  was  removed  on DA  Form  2408-16. 10. If cartridge  is not inserted, install key  washer (16) and  lock  adapter (17).  Lockwire  adapter  to  key washer using  lockwire  (E231). 11. Install  electrical  connector (18).   Secure  it  to adapter (17) with  lockwire  (E231). 14-52







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.