TM 55-1520-240-23-10
13-4
CLEAN HEATER PARTS (AVIM)
(Continued)
13-4
Do not scratch or deform edges of fuel
channels in tip and strainer assembly
parts. Damage to edges can disturb
flow of fuel through parts.
3.
Check body (3), core (2), and fuel strainer (1) for
dirt in thread (4). Use soft bristle brush to clean
thread.
4.
Rinse body (3), core (2), and fuel strainer (1) in
clean dry cleaning solvent (E162). Wear goggles
to protect eyes. Wear gloves (E186).
5.
Dry body (3), core (2), and fuel strainer (1) with
low pressure, filtered, compressed air.
6.
Install two-piece core (2) in body (3).
7.
Install fuel strainer (1) in body (3) fingertight.
8.
Place clean tip and strainer assembly (5) in
plastic bag (E78) until ready to install in heater.
13-22