• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL WINDSHIELD WIPER ARM
REMOVE WINDSHIELD WIPER MOTOR

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  79    80    81    82    83  84  85    86    87    88    89  
TM 55-1520-240-23-10 12-41 INSTALL WINDSHIELD WIPER ARM     (Continued) 12-41 7. Position arm hub (1) on splined shaft (7) above windshield (8). Wiper arm (3) should be as close as possible to parked position.  If wiper arm is in parked position, go to step 11. If wiper arm is not in parked position, go to step 8. NOTE Parked position is at the inboard edge of the windshield. 8. Remove arm (3) and sleeve (6). 9. Rotate sleeve (6) slightly in direction arm (3) must be moved to get arm into parked position. 10. Repeat steps 7 thru 9 until arm (3) can be installed in parked position. 11. Tighten screw (9). 12. Install washer (10) and retaining bolt (11). 13. Lockwire screw (9) and bolt (11) together.  Use lockwire (E233). 14. Remove cotter pin (4) from hole (5). INSPECT 15. Remove protective paper and tape from windshield (8). FOLLOW-ON MAINTENANCE: Adjust windshield wiper arm pressure (Task 12-37). Check windshield wiper system operation (TM 55-1520-240-T). END OF TASK Change 1 12-95







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.