• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
1-75 SERVICE  HOIST  CABLE  CUTTER (Continued) - TM-55-1520-240-23-1_308
1-75 SERVICE  HOIST  CABLE  CUTTER (Continued) - TM-55-1520-240-23-1_310

TM-55-1520-240-23-1 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  271    272    273    274    275  276  277    278    279    280    281  
TM  55-1520-240-23-1 1-75 SERVICE HOIST CABLE  CUTTER (Continued) 1-75 6. Insert  a  long  driftpin  (11) in  chamber  (4).   Tap driftpin  to  drive  out  punch  (11.1) and  cartridge (12). Cutter can  be  damaged  if  pieces  of cut cable  remain  in  cutter body. 7. Clean  chamber  (4).  Use  powder solvent  (E464) and  bristle brush (E84) (13).  Make sure  all pieces of cut  cable  are  removed.  Close  guard  (2). 8. Clean cutter (14) with soft cloth (E128).  Check for cracks and  distortion.  Replace  damaged  cutter. CARTRIDGE  INSTALLATION A  loaded  cutter  is a  hazard.   Insert cartridges  only if  cutter is to  be  used. Do  not  insert  if cutter will  be  stowed. 9. Insert  punch  (11.1)  and  new  cartridge  (12) in chamber (4).  Align  flats in  cartridge  and  cutter. NOTE The  cartridge  first number, installation date,  and  required  date  of  removal shall  be  recorded  on  DA  Form 2408-18  for maintenance  planning. 1-282







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.